


![]() |
![]() |
![]() |
產品展示 - 雷能雙組份高級彩色填縫劑 [返回] |
拌和【Mixing】
將1.54 kg 桶裝的雷能雙組份高級彩色填逢劑A組份粉劑倒入一個裝有0.46kg的B組份液劑的容器內。用慢速機械攪拌器攪拌至均勻無結塊糊狀。靜置熟化2-3分鐘再攪拌一下即可使用。
Pour 1.54kg drum of leanon two-component supreme colored grout part A powder into a bucket containing 0.46 kg of part B liquid,Mix with a mechanical stirrer at low speed until a homogeneous mixture is obtained. let it stand for 2-3 minutes and briefly mix again.
縫隙準備【Preparing the joints】
對多孔吸收性的瓷磚,或施工作業環境非常高溫或大風的情況,需用凈水潤濕磚縫,然后再填縫。針對多孔性瓷磚、金屬色瓷磚\金屬類馬賽克或微晶磚等表面非常細膩的瓷磚時,建議在大面積施工之前,請先進行小面積測試,以確保面材表面效果不受影響。
If tiles are very porous or installed in very hot areas or in the presence of wind wet joints with clean water,For porous ceramic tile,metallic colored tile/metallic colored mosaic, or tile with extremely fine surface such as microlite tile, a trial application on small area should be performed in advance to ensure the tile surface is not being polluted.
使用【Application】
使用合適型號的橡膠刮板填縫,并抹除多余漿料。雷能填縫劑應在2小時內用完。
Fill the joints with the mixture using the adequate squeegee making sure to remove excess paste.The prepared mixture must be used within 2 hours.
縫隙表面修整【Finishing】
經過10-20分鐘,雷能雙組份高級彩色填縫劑失去塑性變得無光澤,此時,則可用合適的微濕海綿擦凈磚面。
Leanon two-component supreme colored grout loses its plasticity and becomes opaque after 10-20minutes.Level and clean the surface with the appropriate dampened sponge.
可供輕載步行:【Set to light foot traffic】
約24小進后。
after approximately 24 hours.
可供使用:【Ready for use】
7天后可投入使用,而水池或游泳池7天后可充水。
Ready for use after 7 days,basins and swimming pools can be filled water after 7days.
存放期:【Storage life】
原包裝不開封在干燥環境中可存放12個月。
12 months in original sealed packaging in a dry area.
執行標準:【standard】
JC/T 1004
JC/T 1004
備注【Further Information】
產品所含水泥成分,接觸體液或汗水時,可能產生刺激堿性反應。施用時應佩戴防護手套、護目鏡??上驅I用戶提供產品安全數據資料。專業入士產品,注意防潮,注意防凍。
Contains cement that when in contact with sweat or other fluids produce an irritant alkaline reaction.Use protective gloves and glasses.Safety data sheet available for professional user on request.PRODUCT FOR PROFESSIONALS.PROTECT FROM HUMIDITY, PROTECT FROM FROST.
技術參考數據(雙組份):
混合比例: | 1.54kg的A組份加0.46kg的B組份 |
施工溫度范圍 | +5℃ 至 +35℃ |
混合物存罐時間 | 約2小時 |
供輕步行荷載時間: | 24小時鐘 |
可供使用: | 7天 |
耐受溫度范圍: | -30℃至80℃ |
顏色: | 多種顏色可供選擇 |
存放期: | 12個月(原包裝裝置于干燥處) |
包裝(雙組份) | 2kg/桶 |
產品特點:
適用于縫寬達6mm
雙組份具高柔性
高強粘結力,耐磨度高
應用范圍:
適用于陽臺、游泳池等家裝施工要求
填縫劑施工步驟:
![]() |
①基層準備 必須干凈,無塵 留瓷磚厚度的2/3作填縫用 瓷磚不可沾濕或存水汽 |
![]() |
②攪拌 按比例兌水以慢速電動攪拌均勻 靜置約2~3分鐘后,略為攪拌后 方可使用 |
![]() |
③填縫 確保磚縫不可有明水 用硬橡膠刮板施工 要飽滿地填入縫里 |
![]() |
④清潔 以濕清潔墊清潔 不要沖刷磚縫 清潔后表面不可留有污漬 |
![]() |
⑤修整 趁填縫劑新鮮粘手時進行表面修整 用少量清水浸濕并扭干 海綿或硬質多孔海綿 海綿不能有滴水的狀態下清潔表面 |