<dd id="s9hmu"><track id="s9hmu"></track></dd>

<s id="s9hmu"><object id="s9hmu"></object></s>
    1. <th id="s9hmu"><pre id="s9hmu"></pre></th>
      <button id="s9hmu"><acronym id="s9hmu"></acronym></button>

      <dd id="s9hmu"></dd><dd id="s9hmu"></dd>
      <button id="s9hmu"><object id="s9hmu"></object></button>
      <progress id="s9hmu"><pre id="s9hmu"></pre></progress>
        您所在的位置: 首頁 產品展示 產品展示 產品展示
        產品展示 - L20 雷能石材及?;u粘結劑 [返回]

        基層準備【Substrate preparation】
        基層必須牢固、干凈、穩定的和無浮塵污垢漆蠟等影響粘著性的物質
        Substrates must be sound,stable and free from dust,grease or any other contamination.


        攪拌【Mixing】
        先將凈水(雷能石材及?;u粘結劑灰/白需加凈水6-6.2kg)倒入一干凈容器內,再將20kg的雷能石材及?;u粘結劑緩慢導入容器中。用慢速機械攪拌器攪拌至均勻無結塊糊狀;靜置熟化5分鐘后再攪拌即可使用。
        First pour clean water(6~6.2kg both for grey &white LeaNon STONE & PORCELAIN TILE ADHESIVE) into a clean container;then slowly add 20kg of LeaNon STONE & PORCELAIN TILE ADHESIVE into the container.Mix with alow-speed mechanical stirrer to obtain a smooth paste free of lumps. Leave to slake for about 5 minutes before remixing again. The paste is then ready for use.


        使用【Application】
        使用合適型號的齒形抹刀將雷能石材及?;u粘結劑涂敷在基面上,然后在指定的晾置時間內將瓷磚鋪壓到位。膠的存罐時間約為8小時。在23℃環境中24小時后即可填縫。
        Apply the LeaNon  STONE & PORCELAIN TILE ADHESIVE paste with a correct-size notched trowel onto the substrate,and lay tiles with a firm pressure within the open time of the adhesive.The pot life is about 8 hours. Ready for grouting after 24 hours at +23℃.


        養護期【Curing time】
        允許輕載通行:24小時以后。允許使用:約14天后。
        Ready for light traffic after about 24 hours.Ready for use after approximately 14 days.


        用量【Consumption】
        約4~8kg/m2或更多膠粘劑,取決于瓷磚的尺寸、質量和基層的條件。
        Around 4~8 kg/m2of mixed adhesive or more depending on tile size and quality of substrate conditions.


        存放期【Storage】
        原包裝未啟封在干燥通風的環境下可保存12個月。
        12 months in original unopened packaging in a dry and ventilated place.


        執行標準【Standard】
        JC/T547: C2TE類;  EN12004: C2TE類。 JC/T547: C2TE  EN12004:C2TE


        備注【Further information】
        產品中的水泥成分與汗水或其他體液接觸時,可能產生堿性反應,所以施用時佩戴保護手套和護目鏡,以小心避免與眼睛和皮膚接觸。詳情請見產品安全資料或聯系本地代理商。專業人士產品。注意防潮
        Contains cement. Cement whe in contact with sweat or other body fluids produces an alkaline reaction,therefore contact with eyes and  with the skin must be carefully avoided by the use of gloves and eye protection.For further information,see the technical data sheet or contact the local distributor.PRODUCT FOR PROFESSIONALS.PROTECT FROM HUMIDITY

        技術參考數據:

        兌水比:                 灰&白色: 每20kg的粉劑加6.0~6.2kg的水
        施工溫度范圍 +5℃  +35℃
        存罐時間 約8小時
        晾置時間 約30分鐘 (根據EN1346標準)
        調整時間: 約60分鐘
        可承受輕步行荷載時間: 24小時后
        可填縫時間                   墻面: 4-8小時
                                        地面: 24小時后
        顏色: 白色、灰色
        存放期: 12個月(原包裝裝置于干燥處)
        用量: 約4-8 kg/m2 或更多
        包裝 20kg/袋

         

        產品特點:

        本產品是新型粘結劑,特別適用于混凝土墻面、混凝土地、石棉水泥板、

        水泥砂漿基面及水泥基防水材料等基面上直接粘貼大理石石材或花崗巖

        等天然石材。

        C2TE類:增強型(2),抗滑移(T),水泥基(C),延長晾置時

        間(E)膠粘劑; 

        易鋪涂,粘結力強;

        高觸變性,即使較重的飾面磚直接施用也不會出現掉磚;

        具一定柔韌性,更可于原于瓷磚面上貼磚。

         

        應用范圍:

         適合粘結室內外地板,墻面的瓷磚,?;u石材和馬賽克,墻身地面在 

        舊有磚面上粘貼瓷磚。適用基面包括灰墻,混凝土磚墻,石膏板,地熱 

        設備地面。

          


        瓷磚膠粘結施工步驟:

        ①基層準備

        基面必須牢固、干凈和完全沒有

        污垢及其他影響粘著性的物質。

        ②拌和&攪拌

        將指定兌水比的清水倒入清潔空桶中;

        用攪拌器攪拌至均勻無強者塊狀

        靜置 5 10 分鐘后再經攪拌膠粘劑

        即可使用。

        ③施用瓷磚膠

        先在基面上批刮一層瓷磚膠以取得高

        粘結強度

        用專業的齒型抹刀涂敷瓷磚膠

        ④瓷磚/石材背面鋪設

        在磚背面薄薄的均勻涂滿膠粘劑

        馬賽克鋪設

        在基面均勻涂滿膠粘劑,并從上至

        下安裝馬賽克

        ⑤鋪壓到位

        用橡皮錘輕輕敲打瓷磚或石材面以

        便瓷磚有更好的接觸(不適用于

        馬賽克)

        30分鐘內進行調縫

        鋪磚后24小時內不得沖刷或雨淋,

        5-7天內防霜防凍或暴曬


        上一張:雷能彩色防霉填縫劑(普通型) 下一張:L11 雷能瓷磚膠
        點擊關閉
        • 客服
        土豪酒店爆爆美女模特